Remember to heat the wire and apply
a small amount of solder from the other side. If you have heated the wire enough the solder
will flow in and around the joint.
The biggest mistake is to use too much solder and not enough heat. You will know when
it's right, it will look shiny with
no cracks. On printed circuit boards, don't let the solder pool and flow between the copper traces
or the thing won't play.
It only takes a little practice to get it right. So are you ready to practice?
Good, here is what you need to do next. Go
shopping for a good soldering iron that works great but is not expensive.
No need to spend alot of money on an iron right now. Later
you will probably want to get a nice soldering station, but for now, let's not spend too
much money while learning to solder and build
working circuits.
While you are there, don't forget to pick up a roll of solder.
Remember to use only rosin core solder. Never use acid core solder as the acid will
eat away the copper printed circuit board and that will be the end of that project!
Soldering Electronic Components isn't hard it just takes a little practice.
